Use Instructions And Limitations; Use For; Do Not Use For - Macurco CD-6G Manual De Operación

Macurco CD-6G Operation Manual

2 Use Instructions and Limitations

The Macurco CD-6G a dual relay Carbon Dioxide (CO
has selectable 4-20 mA output, buzzer and digital display options. It is an electronic detection system used to measure the
concentration of Carbon Dioxide and provide feedback and automatic ventilation control to help reduce CO
CO enrichment areas such agriculture production: cannabis grow rooms, green houses, CO
2
. The CD-6G is a low-level meter capable of displaying from 0 to 5.0% vol. of Carbon Dioxide with a display resolution of 0.01%
vol. (measurement is % by volume). The CD-6G is factory calibrated and 100% tested for proper operation.
Each person using this equipment must read and understand the information in this user manual
before use. Use of this equipment by untrained or unqualified persons or use that is not in
accordance with this user manual, may adversely affect product performance.

2.1 Use For

The CD-6G provides CO detection and automatic ventilation control for CO
2
P P
cannabis grow rooms, green houses, CO
produced both by people exhaling CO
dioxide can vary from 350-450 parts per million (ppm) or higher in areas with high vehicle traffic or industrial activity. The
indoor CO level depends upon the number of people present, how long an area has been occupied, the amount of outdoor
2
P P
fresh air entering the area, enrichment processes, and other factors. CO
per million in areas with many people present for an extended period and where fresh air ventilation is limited. Outdoor "fresh"
air ventilation is important as it can dilute CO
to a room depends on the type of facility and room. Ventilation should keep carbon dioxide concentrations below 1000 ppm
and create indoor air quality conditions that are acceptable to most individuals.
For applications storing or using CO
include but are not limited to food storage, beverage dispensing, agriculture, fire suppression, medical, etc.
N ote: This applies when used in typical indoor ambient air. The CD-6G can be used stand alone, with the Macurco Detection and
4 2 T 4 2 T
Ventilation Control Panel, other 12 VAC or 24 VDC fire/security panels or building automation systems.
Use only for monitoring the gas which the sensor and monitor is designed to detect. Failure to do
so may result in exposures to gases not detectable and cause serious injury or death. For proper
use, see supervisor or user manual, or contact Technical Support at 1-844-325-3050.

2.2 Do NOT use for

The CD-6G is not intended for use in hazardous locations or industrial applications such as refineries, chemical plants, etc. Do
not mount the CD-6G where the normal ambient temperature is below 32°F or exceeds 122°F (0°C or above 50°C). The CD-6G
mounts on a type 4S electrical box supplied by the contractor. Do not install the CD-6G inside another box unless it has good air
flow through it.
This equipment may not function effectively below 32°F or above 122°F (0°C or above 50°C). Using
the detector outside of this temperature range may adversely affect product performance.
REV – 1.0
) detector, controller, and transducer available in low voltage. The CD-6G
2
P P
WARNING
storage rooms, CO processes, etc. Carbon dioxide is a colorless, odorless gas that is
2 2
as well the burning of gasoline, coal, oil, and wood. The outdoor concentration of carbon
2
P P
levels of the indoor environment. The amount of fresh air that should be supplied
2
P P
tanks, the detector will provide notification in the event of a gas leak. Such applications
2
P P
WARNING
WARNING
[34-2900-0510-9 ]
storage rooms, CO
2
enrichment areas such agriculture production:
2
concentrations indoors can vary several hundred parts
2
P P
concentrations in
2
P P
processes, etc.
2
6
| P a g e