Goobay 39513 Instrucciones De Uso página 18

User Manual
Fig. 13: Mounting rotor
Fig. 14: Mounting front protective grille
Fig. 15: Ready mounted table fan
20 Grip 21 Pin for rotation adjustment
22 Rotary switch for setting the blower power
23 Tilt adjustment screw
End of mounting.
18
15. Turn the Phillips-head screw (16) on the
spacer (15) of the rotor (10) counterclock-
wise until a well-permeable opening is
obtained.
16. Push the rotor (9) with the spacer first onto
the motor axis (14).
The rotor with the spacer must not rest
directly on the engine block. See Fig. 13.
17. Tighten the Phillips head screw on the
spacer clockwise again.
18. Slide the front guard grille (8) with the
hanger (17) over the upper edge of
the rear guard grille. Fig. 14 a).
19. Check whether the two hole recesses (18)
are flush with each other at the bottom
of the protective grille frames. Fig. 14 b).
20. Slide the 4 locking clamps (19), each
located on the side of the front protective
grill, over the frames of both protective
grills. Fig 14 c).
21. Push the Phillips-head screw with lens
head (8a) through the hole recesses (18)
of the protective grille. Fig. 14 b).
22. Fix them with the screw nut (8b).
23. Tighten the Phillips head screw clockwise.