IKEA SAMFALLD Manual Del Usuario página 20

BEFORE YOU CALL
Cooktop Problems
Problem
The number in the setting
indicator is fl ashing.
The letter E appears in a
setting indicator
The letter L appears in the
setting indicators.
The cooktop deactivates
A signal sounds when the
cooktop is not operating
The Hot Cooktop warning
did not come on
The control area becomes
hot
A dash (-) shows in the
setting indicator
20
Cause / Solution
Incorrect cookware used. See "Using Proper Cookware" on page 9.
Cookware is the wrong size or incorrectly positioned in the cooking zone. See
"Pan Sensing" on page 10.
An error has occurred. This may happen because cookware has boiled dry.
Remove cookware and turn off the cooktop. After 30 seconds, turn on the
cooktop. If the cookware was the problem, E will no longer display.
An error may occur because of water, oil, or food on the controls. Clean the
control panel.
Disconnect the power to the cooktop for a minute, then reconnect it. If the
error still occurs, call an authorized dealer or service technician.
The cooktop is locked. See "Lock or Unlock the Cooktop" on page 15.
There is an object on the controls. Remove the object. See "Key-Stuck Func-
tion" on page 16.
The cooktop did not get hot enough to activate the warning.
If the cooktop was running long enough for the surface to get hot, call an
authorized dealer or service technician.
The cookware is too large or too close to the controls. Put large cookware on
a rear zone if possible.
This zone cannot be used until the cooktop is turned off, then turned on. The
other zones are still operable.
EN