Roland KSC-68 El Manual Del Propietario

Keyboard stand for F-20
Before using this stand, carefully read the sections entitled "USING THE UNIT SAFELY" and "IMPORTANT NOTES. " Additionally this manual should be saved and
kept on hand as a convenient reference.
•
Make sure that another person is on hand to help with the assembly and setup.
•
Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your
hands or feet.
•
Prepare an area in which you can perform the assembly safely.
•
Do not use a power tool (e.g., an electric screwdriver) to assemble the stand. You risk damaging or
stripping the screws.
•
The KSC-68 is designed specifically to be used with the F-20.
Parts Check
Before you begin assembling the stand, check that all the parts were
supplied.
1
A C B
2
3
Assembly Procedure
* You will also need to have a Phillips screwdriver.
* Fasten each screw tightly, then place the stand in a stable and horizontal place.
* Do not allow the pedal cord or power cord to get twisted or pinched while
assembling the stand.
* In the interest of product improvement, the specifications and/or appearance of this
stand are subject to change without prior notice.
1 Stand Assembly
At first, assemble the entire stand in a temporary fashion, without really
tightening the screws. Then, after checking the overall alignment of the
boards (and gently shifting certain parts where necessary), go around and
tightly fasten each of the screws.
1.
Attach the side board (left) for the left sides to the center board
(so that the metal parts face inside) using screws "a" (M5 x 20
mm).
2.
Use screws "a" (M5 x 20 mm) to attach the side board (right) in
the same way.
Front
2
1
Rear
Center board
Side board (left)
Side board (right)
Screw "a"
(x 6)
Position the metal
parts of the center
board so that they
face the rear.
1
KSC-68
Owner's Manual
A Side board (left) 1 pcs.
B
Side board (right) 1 pcs.
C Center board 1 pcs.
1 Screw "a" (M5 x 20 mm) 10 pcs.
2 Headphone hook 1 pcs.
3 Screw "b" (M4 x 16 mm) 2 pcs.
2 Installing the Piano on the Stand
1.
Set the piano on the stand, then firmly attach the four screws
"a" (M5 x 20 mm).
* When handling the piano, firmly grasp it. Be careful, so you do not get your fingers
pinched.
Underneath the
Piano
Screw "a" (x 4)
Please don't get your fingers
pinched!
Side board
Fasten the screws so
that the stand does not
protrude outward.
3 Attaching the Headphone Hook
1.
Attach the headphone hook using screws "b" (M4 x 16 mm).
Headphone hook
Screw "b" (x 2)
* 5 1 0 0 0 3 6 1 4 0 - 0
USING THE UNIT SAFELY
About WARNING and CAUTION Notices
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
ALWAYS OBSERVE THE FOLLOWING
WARNING
Do not disassemble or modify by yourself
Do not carry out anything unless you
are instructed to do so in the owner's
manual. Otherwise, you risk causing
malfunction.
Do not repair or replace parts by yourself
Refer all servicing to your retailer, the
nearest Roland Service Center, or an
authorized Roland distributor, as
listed on the "Information."
Do not use or store in the following types of
locations
• Subject to temperature
extremes (e.g., direct sunlight
in an enclosed vehicle, near
a heating duct, on top of
heat-generating equipment);
or are
• Damp (e.g., baths, washrooms,
on wet floors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and
shakiness.
Do not place in an unstable location
Otherwise, you risk injury as the
result of the stand toppling over or
dropping down.
Be cautious to protect children from injury
Always make sure that an adult is on
hand to provide supervision and
guidance when using the stand in
places where children are present, or
when a child will be using the stand.
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
Copyright © 2013 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Roland is a registered trademark of Roland Corporation in the United States and/or other countries.
1 *
Placement
About the Symbols • Do not expose the stand to direct sunlight,
place it near devices that radiate heat, leave
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is it inside an enclosed vehicle, or otherwise
determined by the design contained within the triangle. In
subject it to temperature extremes. Also, do
the case of the symbol at left, it is used for general
not allow lighting devices that normally are
cautions, warnings, or alerts to danger.
used while their light source is very close to
The symbol alerts the user to items that must never be
carried out (are forbidden). The specific thing that must
the stand (such as a piano light), or powerful
not be done is indicated by the design contained within
spotlights to shine upon the same area of the
the circle. In the case of the symbol at left, it means that
stand for extended periods of time. Excessive
the unit must never be disassembled.
The symbol alerts the user to things that must be heat can deform or discolor the stand.
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
• Do not allow rubber, vinyl, or similar materi-
case of the symbol at left, it means that the power-cord
als to remain on this stand long periods of
plug must be unplugged from the outlet.
time. Such objects can deform or discolor the
stand.
WARNING
• Do not paste stickers, decals, or the like
to this stand. Peeling such matter off the
Do not drop or subject to strong impact
instrument may damage the exterior finish.
Otherwise, you risk causing damage
• Depending on the material and temperature
or malfunction.
of the surface on which you place the stand,
its rubber feet may discolor or mar the
surface.
You can place a piece of felt or cloth under
CAUTION
the rubber feet to prevent this from happen-
ing. If you do so, please make sure that the
Use the stand only for the specified products
stand will not slip or move accidentally.
This stand is designed specifically to
Maintenance
be used with the Roland F-20. If
used in combination with other
• To clean the stand, use a dry, soft cloth; or
products, you risk sustaining injuries
one that is slightly dampened. Try to wipe
as the result of the product dropping down or
the entire surface using an equal amount of
toppling over due to a lack of stability.
strength, moving the cloth along with the
grain of the wood. Rubbing too hard in the
Evaluate safety issues before using stands
same area can damage the finish.
Even if you observe the cautions
given in the owner's manual, certain
• Never use benzine, thinners, alcohol or
types of handling may allow F-20 to
solvents of any kind, to avoid the possibility
fall from the stand, or cause the
of discoloration and/or deformation.
stand to overturn. Please be mindful of any
• As with any wood-crafted product, some
safety issues before using this product.
expansion and contraction of the wood
Avoid climbing on top of the stand, or placing
can occur depending on the way the stand
heavy objects on it
is used and the environment in which it
is used. Over time, this can cause some of
Otherwise, you risk injury as the
the screws to start coming loose. To ensure
result of the stand toppling over or
safe, worry-free use of the stand, you should
dropping down.
periodically check the tightness of the screws
shown in the illustrations in the "Assembly
Keep small items out of the reach of children
Procedure." If you find any that are loose, use
a screwdriver to tighten them.
To prevent accidental ingestion of
the parts listed below, always keep
them out of the reach of small
children.
• Removable Parts
Screw
For C.A. US (Proposition 65)
WARNING
IMPORTANT NOTES
1