Troubleshooting - Fellowes Starlet 90 Manual Del Usuario

SET UP
1
1. Ensure the machine is on a
stable surface.
BEFORE YOU BIND
1
1. Select the correct comb diameter.
STEPS TO BIND
Front
Cover
Back
Cover
1. Punch front and back covers first.
CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by opening and
then closing the comb as previously described.
STORAGE
Lower the punch handle to the horizontal position. Lower the lid. The Starlet comb binder is designed to be stored horizontally or vertically.
There are feet that enable them to stand upright.

TROUBLESHOOTING

Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge.
Partial holes
Damaged hole edges
Waste tray leaks
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from the date of purchase by the original
consumer. If any part is found to be defective during warranty period, your sale and exclusive remedy will be repair or replacement, at Fellowes'
option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling or unauthorised repair. Any implied
warranty, including that of merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate warranty period set
2
2. Check waste tray is empty and
correctly fitted.
2
2. Insert the plastic comb into
the mechanism.
2
Max
7
30
(80gsm/20lbs)
2. Punch sheets in small batches
that do not overload the machine
or the user.
Cause
Edge guide not set
Blockage
Debris is stuck below dies.
Sheets not correctly aligned to punch pattern.
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst feature' has activated
3
3. Lift the lid. Ensure the comb-
opening lever is pushed backwards.
3
3. Pull comb-opening lever
forward to open the comb.
3
3. Load punched sheets directly
onto the opened comb. Starting
with the front of the document.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For
best results empty the tray regularly.
Solution
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper entry.
Take stiff cardboard and slide into the paper entry. Move the cardboard sideways
to release any stray clippings into the waste tray.
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of sheets being punched.
Check waste tray is empty and 'burst feature' is closed.
forth above. In no event shall Fellowes be liable for any consequential damages attributable to this product. This warranty gives you specific legal
rights. You may have other legal rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide,
except where different limitations, restrictions or conditions may be required by local law. For more details or to obtain services under this
warranty, please contact Fellowes or your dealer.
4
4. Lift the punch handle to its
upright position.
4
4. Test punch scrap sheets to check
edge guide setting.
4
4. When all punched sheets are loaded
onto the comb, push the comb lever
backwards to close the comb and
remove the bound document.
3