How To Hang Your Ceiling Fan - Fanimation TWOFOLD LP8551LBN Manual Del Usuario

WARNING
To avoid possible fire or shock, be sure electricity is
turned off at the main fuse box before hanging.
(Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7' of clearance from
floor to ceiling fan. (Figure 2)
1. Securely attach the hanger bracket to the outlet
box (not included) using the outlet box screws and
washers supplied with the outlet box. (Figure 3)
WARNING
The outlet box must be securely anchored. Hanger
bracket must seat firmly against outlet box. If the outlet
box is recessed, remove wall board until bracket
contacts box. If bracket and /or outlet box are not
securely attached, the fan could wobble or fall.
2. Carefully lift the fan and seat the downrod/hanger
ball assembly onto the hanger bracket that was just
attached to the outlet box. Be sure the groove in the
ball is lined up with tab on the hanger bracket.
(Figure 4) This fan is intended for standard and angled
mounting options only. Closemount and flushmount
options are not available. For angled ceilings, note the
angle can be no more than 19°.
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.

How to Hang Your Ceiling Fan

Ceiling
Floor
Outlet Box
Hanger
Bracket
Flat Washer
Screws (2)
Supplied with
Outlet Box
Hanger
Bracket
9
Main Fuse Box
Figure 1
No Less
Than
7 Feet
Figure 2
Tab
Figure 3
Outlet Box
Downrod/Hanger
Ball Assembly
Figure 4