How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation TWOFOLD LP8551LBN Manual Del Usuario

How to Install Your Canopy Housing

NOTE: This step is applicable after the neccessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Position blade-side A along the motor, aligning
blade holes with holes at the bottom of the motor
assembly flywheel. Make sure the blade-side A is fully
seated against the flywheel and install 1/4"-20 screws
and blade plate. Don't fully tighten at this time.
(Figure 1)
2. Position blade-side B next to blade-side A and
aligning blade holes with holes at the bottom of the
motor assembly flywheel. Make sure the blade-side B
is fully seated against the flywheel and install 1/4"-20
screws and blade plate. Don't fully tighten at this time.
(Figure 2)
3. Assemble the remaining blades according to
Step 1 and Step 2, then securely tighten all previously
installed screws.
Shoulder Screw
Motor Assembly
Blade Plate
1/4"-20
Screws With Lock Washers
(3 each per blade)
Motor
Assembly
Blade Plate
1/4"-20
Screws With
Lock Washers
(3 each per blade)
1/4"-20
Screws With
Lock Washers
Blade Plates
12
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Blade - Side A
Figure 1
Blade - Side B
Figure 2
HARDWARE USED:
x 12
x 4
Blade -
Side A