Maintenance; Fireplace Surface Cleaning - Empire EBL74 El Manual Del Propietario

Operation
Remote Control Battery
Replacement
To replace the battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 3 Volt
(CR2032 [longer life] or

Maintenance


W ARNING: Disconnect
power and allow heater to
cool before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
!
NOTE: The fireplace should
not be operated with an accu-
mulation of dust or dirt on or
in the unit, as this can cause
a build up of heat and even-
tual damage. For this reason
the heater must be inspected
regularly, depending upon
conditions and at least at
yearly intervals.
Partially Reflective Glass
Cleaning
The partially reflective glass is
cleaned in the factory during the
assembly operation. During ship-
ment, installation, handling, etc.,
CR2025) battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area
the partially reflective glass may
collect dust particles; these can
be removed by dusting lightly with
a clean dry cloth.
To remove fingerprints or other
marks, the partially reflective
glass can be cleaned with a damp
cloth. The partially reflective glass
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching, do
not use abrasive cleaners.

Fireplace Surface Cleaning

Use only a damp cloth to clean
painted surfaces of the fireplace.
Do not use abrasive cleaners.
Servicing
Except for installation and clean-
ing described in this manual,
an authorized service repre-
sentative should perform any
other servicing.
17