Fireplace Installation; Site Selection; For Bathroom Use - Empire EBL74 El Manual Del Propietario

Fireplace Installation

Site Selection

Review and consider all of the fol-
lowing conditions before installation:
• Dimensions of the unit: 74.1 in.
(1883 mm) x 19.4 in. (494 mm)
• For surface installation, the unit
requires a minimum of 2 wall
studs in order to ensure secure
installation. For other installa-
tion methods, suitable framing is
required.
There are two possible mounting
methods:
• Surface mount (pg. 10);
• Flush mount (pg. 11).
WARNING: The top of the
fireplace is to be installed at least
4" (10.2 cm) from the ceiling.
CAUTION: Ensure installation
does not allow fireplace to be
in direct contact with building
vapor barrier or insulation and
meets all local building code.
!
NOTE: A dedicated, properly
fused 15 Amp circuit is required,
rated for the appropriate voltage
(120V, 240V).
WARNING: Construction and
electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING: To reduce the risk of
fire, do not store or use gasoline
or other flammable vapors or liq-
uids in the vicinity of the heater.
1. Select a location that is not
susceptible to moisture and is
away from drapes, furniture and
high traffic.
2. Unpack the fireplace, front glass
and hardware from the box and
remove all packaging materials
before installation.
3. Store the fireplace in a safe, dry
and dust free location until you
are ready to install the fireplace.

For Bathroom Use

If this unit is installed in a bathroom it
must be protected by a GFI recep-
tacle or circuit. If receptacle is used it
must be readily accessible.
To prevent electrical shock this
unit is an electrical appliance that
is NOT watertight and must be
installed as to prevent water from
entering unit. This must be installed
away from showers, tubs, etc.
Never locate fireplace where it may
fall into a bathtub or other water
container.
7