Fan Assembly. Pgs - Litex Industries E-AVA52BNK5CR Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 6in.
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the 6in. downrod,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. Slide downrod through canopy and yoke
cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
Place downrod into the motor housing yoke and re-
insert pin and clip. Securely tighten yoke set screws
and nuts. Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
A
electrical wiring
clip
page 4
set screw hole
stop pin
hanging ball
B
downrod
canopy
yoke cover
yoke set screw
pin
motor
housing