Canopy Assembly; Blade Assembly - Litex Industries E-AVA52BNK5CR Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed, and then tighten both screws
securely.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with washers)
with fingers first, and then tighten screws
securely with Phillips screwdriver. Repeat
procedure for remaining blades.
Remove blade arm screws and lock washers
from fan motor and set aside. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes
and attach blade arm with lock washers and
blade arm screws. Before securing screws
permanently, repeat this procedure with
remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
screw
canopy
motor
housing
fan motor
page 6
hanging bracket
screw
blade attachment
screws and washers
blade
blade arm
blade arm screws
and lock washers