Remote Control Operation; Testing Your Fan - Litex Industries E-AVA52BNK5CR Guia De Instalacion

10. Remote Control Operation.

LIGHT button - Tap once to turn light ON or OFF.
Liquid crystal display shows the amount of
brightness as a percentage. Holding the button
down for more than 2 seconds will cycle light
through brightness settings. When turning the
light back ON, light will return to the same
brightness setting it was on when light was last
turned OFF.
FAN button - cycles through 3 fan SPEEDS and
then returns to the OFF setting.
FOR/REV button - used to REVERSE blade
direction only when fan is set to low speed.

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Remote
control will show each function as a button is
pressed if battery is installed correctly.
Test fan speeds with the remote control. Test the
light ON/OFF function with the remote control as
well. Test the dimmer function by holding the
LIGHT button down for more than 2 seconds. If
fan and/or light do (does) not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Fan must be set on LOW when pressing the
reverse button. Use reverse function to recirculate
air depending on the season.
light dimmer setting
page 8
fan setting
reverse setting