Blade Bracket; Attaching The Blades To The Blade Brackets; Light Kit Fitter Assembly - HAMPTON BAY 52129 Guía De Uso Y Cuidado

Assembly - Attaching the Blades
2
Attaching the blades to the blade
brackets
□
Mount the fan blade (G) to the blade bracket (F) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade bracket (F).
□
Hold the blade (G) with both hands close to the blade bracket
(F) down firmly. Ensure the key-slot holes are properly
seated on the blade bracket (F) posts.
□
While still holding the blade (G) down with both hands, firmly
slide the blade (G) until it engages in the locking mechanism
(UU). Make sure the locking mechanism (UU) at the rear of
the blade bracket (F) springs upward and butts against the
edge of the blade (G), indicating a secure connection.
□
Visually inspect the top of the blade bracket (F) to ensure the
locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (G).
Assembly - Attaching the Light
1
Attaching the light kit fitter assembly
IMPORTANT: It is critical to attach the light kit pan using the
quick connector. The fan will not operate unless the light kit
pan is connected to the fan.
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
□
Remove the three screws (LL) from the light kit fitter assembly
(H) and save them.
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□
Align the three holes in the switch cup below the fan motor
assembly (E) with the three holes in the switch cover of the
light kit fitter assembly until it clears the reversing switch in
the switch cup.
□
Re-install the screws (LL) that were removed in step 1.
□
Make sure all the screws are firmly tightened.
UU
F
E
LL
H
11
Please contact 1-855-HD-HAMPTON for further assistance.
E
G
HAMPTONBAY.COM