E Fan-Motor Assembly; Assembly - Attaching The Blades - HAMPTON BAY 52129 Guía De Uso Y Cuidado

Assembly - Hanging the Fan (continued)
5
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover (FF) for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws
(II) and alignment post (QQ) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the
alignment post (QQ) engage to the round hole and the
screws (II) engage to the key slots.
□
Firmly tighten the two mounting screws (II).
□
Align the oval shape on the canopy (C) with canopy bottom
cover (FF). Push up the canopy bottom cover (FF) until the
screw (II) heads engage to the slots on the canopy bottom
cover (FF) so that the magnetic canopy bottom cover (FF)
can be attached to the bottom of the canopy (C) properly.

Assembly - Attaching the Blades

1
Fastening the blade brackets
to the motor
IMPORTANT: The switch cup (RR) has an access hole (ZZ)
to allow the screwdriver to reach the screws on the blade
bracket (F).
WARNING: Remove the rubber motor stops on the bottom
of the fan before installing the blades or testing the motor.
□
Fasten the blade bracket (F) to the fan-motor assembly (E) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the pre-installed blade bracket (F) screws
by instering a screwdriver through the access hole (ZZ).
□
Repeat this step for the remaining blade bracket by rotating
the motor until the next blade bracket screw can be accessed
through the access holes (ZZ) in the switch cup cover.
RR
10
QQ
F
ZZ
A
II
C
B
FF
E