K2 Pumps WPS07505PCK Manual Del Usuario página 4

TOOLS REQUIRED
Flathead
Screwdriver
Safety goggles
MATERIALS REQUIRED (NOT INCLUDED)
Discharge tee
Threaded adapter
Ball valve
Union
SPECIFICATIONS
POWER SUPPLY
LIQUID TEMP. RANGE
DISCHARGE
SUCTION
WATER LEVEL
INSTALLATION
CAUTION: Risk of flooding. Be sure that all plumbing and fittings are rated to withstand the system pressure which you
expect the pump to generate.
NOTE: Installation of a low pressure safety cutoff switch on the pump discharge is recommended (and may be required
by your local code) to shut off the power in case of low discharge pressure (caused by broken pipe, etc.).
A． Shallow Well Installation (For 0-25 ft. well)
1. Connect the suction pipe to the pump inlet.( Figure 1 )
2. Prime the pump (Figure 2).
3. Connect the pump outlet to the water system in your house (Figure 3).
4. Plug the pump into 115V GFCI outlet to operate refer to OPERATION section on page 7.
Figure 1
4
Phillips
Screwdriver
Tape Measure
Pipe
Elbow
Check valve
115V,60HZ,20Amp circuit
32°F to95°F (0°- 35°C)
1in.NPT
1in. NPT
25 ft.
Figure 2
Pipe wrench
Thread Tape
Figure 3
For Professional Technical Support call 1-844-242-2475
Hacksaw
PVC glue