Attaching The Fan Blades - Progress Lighting AirPro P250008 Instrucciones De Instalación

Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling canopy with
the two screws in the mounting bracket. Push up
to engage the slots and turn clockwise to lock
in place. Immediately tighten the two mounting
screws firmly.
2. Install the remaining two mounting screws into
the holes in the canopy and tighten firmly.
3. Install the decorative canopy ring by aligning the
ring's slots with the screws in the canopy. Rotate
the ring counter-clockwise to lock in place.
4. You may now proceed to attaching the fan blades.
Attaching the Fan
Blades
NOTE: Your fan blades are reversible. Select the
blade finish which best accentuates your decor.
1. Attach blade to blade bracket using screws shown
in Figure 14. Please note that the rubber washers
are preattached to the blade bracket. Start a screw
into the bracket. Repeat for the two remaining
screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
tightening the motor screws. Please note that
the motor screws are preattached into the blade
brackets. (Figure 15)
4. Repeat steps 1,2 & 3 for the remaining blades.
Attaching the Switch
Housing
1. Remove the three mounting screws on the switch
housing cover below the motor.
2. Connect the wires exiting the bottom of the motor
with switch housing by connecting the molded
adaptor plugs together.
3. Attach the switch housing and secure it to the
switch housing cover using the three screws that
were removed. (Figure 16)
Screws
Blade
Blade Bracket
Slot
Alignment Post
Screws
Blade
Switch Housing
Cover
Molded Adaptor
Switch Housing
Plugs
Figure 14
Figure 15
Mounting
Screws (3)
8.
Figure 16