Progress Lighting AirPro P250008 Instrucciones De Instalación página 9

Installing Fan to
the Electrical Box
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING BRACKET MUST BE MOUNTED
SO THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
BRACKET FROM THE TOP DOWN.
1. Pass the 120-Volt supply wires through the
center hole in the mounting bracket.
(Figure 11)
2. Install the mounting bracket on the outlet
box by using the two screws provided with
the outlet box. If necessary, use leveling
washers (not included) between the
mounting bracket and the outlet box. The
flat side of the mounting bracket should
face toward the outlet box, as shown.
(Figure 11)
3. Securely tighten the two mounting screws.
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
4. Carefully lift the fan-motor assembly up to
the mounting bracket.
5. Insert the ball portion of the ball/downrod
assembly into the socket of the mounting
bracket.
6. Turn the ball/downrod assembly clockwise
until it is seated with the tab of the mounting
bracket aligned with the slot in the ball.
(Figure 12a)
7. If using close-to-ceiling mounting, hang the
fan on the hook provided by utilizing one
of the holes at the outer rim of the ceiling
canopy. (Figure 12b)
UL Listed
Electrical
Box
Ceiling
Mounting
Bracket
Hook
120V Wires
Washers
Mounting
Screws
(Supplied with
Electrical Box)
Figure 11
Standard Mount
Figure 12a
Close-to-Ceiling Mount
Figure 12b
6.