Technical Data; Troubleshooting - BLACK&DECKER FSM1630 Manual De Instrucciones

Empty the water tank (3).
u
Remove the cleaning pad (6 or 7) and wash it ready for
u
next use. (Take care to follow the wash care instructions
printed on the cleaning pad).
Wrap the supply cable around the cable tidy hooks (10 &
u
11).
Note: The top cable tidy hook (11) rotates to easily release the
cable ready for next use.
Clip the supply cable onto itself using the cable tidy clip
u
(22) close to the plug.
Place steam mop on the resting mat (8) for storage.
u
Note: With the handle (4) in the upright position, the cable
neatly wrapped around the cable tidy hooks (10 & 11) and
secured with the cable tidy clip (22) your steam mop will stand
on its own for storage. Alternatively there is a hanging bracket
(23) built into the hand grip (24) which will allow your steam
mop to be hung from a suitable hook on the wall. Always
ensure that your wall hook is capable of supporting the weight
of the steam mop safely.

Technical data

Voltage V
ac
Power W
Tank capacity ml
Weight
kg

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local Black & Decker repair agent.
Problem Step Possible solutions
Check the unit is plugged in at the wall
The steam mop is 1
socket.
not turning on.
Check the unit is switched on using the on/
2
off switch (1).
3 Check the fuse in the plug.
Check that the handle (4) of the steam mop
The digital controls 4
is pushed firmly into the steam mop body
do not light up.
(13). Check that the arrow on the handle is
flush with the top of the steam mop body
(13).
5 Check steps 1, then 2, then 3.
FSM1630
(Type 1)
230
1600
500
3.4
(Original instructions)
Problem Step Possible solutions
The steam mop will only produce steam
The steam mop is 6
once the handle is pulled back from the
not producing
upright position.
steam.
Check that the water tank (3) is full and
7
correctly fitted.
NOTE: When first filled or after running dry it
can take up to 45 seconds for steam to be
produced.
Check that the Steam head (5) is firmly
8
docked into the steam mop body (13).
9 Check steps 1, then 2, then 3.
The digital controls 10
Check steps 4, then 5, then 1, then 2, then 3
go out during use.
The steam mop 11 Check steps 6, then 7, then 8, then 4, then 3.
stops producing
steam during use.
The steam mop has 3 settings. Press the
The steam mop is 12
autoselect button (2) to reduce the amount of
producing too
steam being produced.
much steam during
use.
Check that the steam burst button (21) has
13
not been pressed.
The steam mop has 3 settings. Press the
The steam mop is 14
autoselect button (2) to increase the amount
producing too little
of steam being produced.
steam during use.
Press the steam burst button (21) to
15
temporarily increase the amount of steam.
Refer to the assembly chapter of the manual
Steam is escaping 16
for correct fitting instructions of all parts and
from unexpected
accessories.
areas of the unit.
Where can I get 17 www.blackanddecker.co.uk/steammop
further information www.blackanddecker.ie/steammop
/ accessories for
my steam mop.
ENGLISH
7