Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
cod.?7&45
"
apillon·
blade re-sharpened or replaced by a customer service centre (measurement of imbalance).
Unbalanced blades will cause the brushcutter
to
vibrate violently-risk of accident!
Change and clean the spark plug
1) Once the engine has cooled, remove the spark plug using the socket spanner.
2) Clean the plug with a wire brush.
3) Using a feeler gauge; set the gap
to
0.6-0.7 mm.
4)
Install the spark plug carefully by hand,
to
avoid cross-threading.
5) After the spark plug Is In place, Ughten with spanner
to
compress the washer.
Clean the air filter
Unclip the air filter cover and remove the sponge filter element. To avoid objects falling into the air
tank, replace the air fitter cover. Wash the filter element in
warm
soap
water,
rinse and allow it
to
dry
naturally.
Wamlngl
Never run the engine without the air filter element installed.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit in a dry room, allow the motor to cool down
beforehand.
Troublnhooting
Before perfonning any maintenance or cleaning work, always turn
off
the engine and
wait
until the cutter has come to a standstill
1) Engine does not run:
--Reassemble the blade or Nylon cutter.
--check the fuel level.
2) Engine power drops:
--Have cutting blade re-sharpened /replaced (customer service centre)
3) If the temperature af machines Is too high:
--insure the machines have rest at regular time.
Faulta which cannot be rectified with the aid
of
this table may be rectified by a specialist company
only (customer service
centre).
40
Publicidad
Tabla de contenido
