Leggett & Platt Style Glass Top Manual Del Usuario página 4

REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 2 BASES
STEP 1
Plug both bases into power outlet. Operate each base with its
respective remote control to verify the base functions properly.
Lower both bases to the flat position.
STEP 2
UNPLUG both bases.
STEP 3
Place both bases on their sides close to each other.
CAUTION: DUE TO RISK OF INJURY, TWO ADULTS ARE
REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE.
STEP 4
Locate the sync cable (FIGURE 4).
FIGURE 4
SYNC CABLE
STEP 5
Plug one end of the sync cable into the sync port (on the control
box) of base 1. Plug the other end of the sync cable into the
sync port (on the control box) of base 2 (FIGURE 5).
FIGURE 5
BASE 1
CONTROL
BOX
4
UBL
HEAD
SNORE
HEAD
REMOTE
CONTROL 1
STEP 6
Turn both bases over onto their legs.
CAUTION: MAKE SURE SYNC CABLE IS NOT CAUGHT IN BASE
OR PINCH POINTS.
STEP 7
Plug both bases back into power outlet.
STEP 8
Operate the remote control(s) to verify both bases function
correctly. If using only one remote control to operate both bases,
store the second remote for use as a spare.
Note: To revert back to 1-to-1 programming, remove sync cable
from control boxes.
SYNC
PORT
SYNC
CABLE
LOCK UBL LOCK
FOOT HEAD FOOT
FLAT FLAT
MEM ZGRAV SNORE MEM ZGRAV
SET SET
MASSAGE FOOT HEAD MASSAGE FOOT
REMOTE
CONTROL 2
BASE 2
CONTROL
BOX
SYNC
CABLE
BASE 1
BASE 2
SYNC
PORT