Brita PURITY Quell ST Manual página 26

4.2 Assembling the Pressure Vessel and the Pressure Vessel Lid
4.3 Assembly of Inlet and Outlet Hoses
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The use of
BRITA hose sets is recommended (Chapter 13).
•
Fit inlet hose
connector head
Note: Inlet "IN" and outlet "OUT" of the connector head
seals, therefore no additional flat seals may be used here. Check that the O-rings are seated
correctly.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed 15 Nm!
!
Only hose connections with flat seals may be used. Hoses with conical screwed connections
damage the filter head connections and invalidate any guarantee claims. Only hoses that comply
with DVGW-W 543 may be used to connect the device.
Before assembly, note the direction of flow on the upper side of the filter head, "IN" = water inlet,
"OUT" = water outlet. Prior to installation, note installation dimensions and operating position
EN
(Chapter 12). If no original hoses are used, the 1"–3/4"
the return valve is sealed correctly (pre-fitted in the water inlet).
5 Commissioning a New Filter
5.1 By-pass setting for filter systems without and with measuring and display unit
•
For PURITY Quell ST filter systems: identify the local carbonate hardness in degrees of
German hardness °dH (BRITA nomenclature °KH) using the enclosed carbonate hardness test.
•
Check the by-pass setting on the by-pass adjuster
Note: A 30% by-pass setting has been made in the factory, and might be changed to suit the
local carbonate hardness or total hardness and the application (Chapter 7).
22
• Stand with both feet on the kick loops
•
Lift the pressure vessel
are over the kick loops
•
Remove the transport protective cap
• Check that the O-ring seal of the filter cartridge
groove and also check for dirt and damage.
Note: the cartridge seat has been lubricated with food-safe lubricant at the
factory.
• Stand on the kick loops
on the pressure vessel
must match the "INSERT" groove.
20
•
Press the pressure vessel lid
engages.
at the inlet of the connector head
6
.
4
.
12
and turn it clockwise until the mantle handles
1
.
12
from the filter cartridge.
18
with both feet and place the pressure vessel lid
12
. The position of the arrow marking on the lid handle
1
down and turn clockwise until the lock
3
and outlet hose
4
are equipped with O-rings as
4
adapter supplied must be used to ensure
17
.
19
is correctly seated in the
2
at the outlet of the
10
16
3
15