Bosch DL 0 607 460 400 Instrucciones De Servicio página 9

BS7460_gb_3609929100_t.fm5 Seite 1 Montag, 14. August 2000 2:37 14
Product Specifications
Pneumatic Driver Drill
Order number 0 607 460 400
No-load speed
Power output
Maximum tightening torque
Maximum screw diameter
Rotational direction
Tool holder
Switch start
Disengaging clutch
Rated pressure
Hose connection fitting
Inside hose dia.
Air consumption under load
Weight (without accessories)
approx.
Product Elements
1 Tool holder
2 Depth stop
3 Clamping area
4 Right/Left rotation switch
5 Hose connection piece
6 Air outlet with silencer
7 On-Off switch
Not all the accessories illustrated or described are in-
cluded in standard delivery.
Noise/Vibration Information
Measured values determined according to EN 50 144
(Rated pressure).
The A-weighted sound pressure level of the tool is typ-
ically 78 dB(A). The noise level when working can ex-
ceed 85 dB(A).
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
Intended Use
The machine is intended for the screwing in of self-tap-
ping screws with depth stop.
[RPM] 750
[W] 320
In addition, the Section Safety Instructions for
[Nm] 1.5–8
Pneumatic Tools must be observed.
Before using for the first time, ask for a practical
[mm] 6.3
demonstration.
s
1/4"
q
q
[bar/psi] 6.3/90
G 1/4"
[mm] 10
[l/s] 7
s
[kg] 0.80
s
s
s
s
s
s
s
s
Air Supply
The supplied air must be free of foreign material and
humidity to protect the machine from damage, con-
tamination and rust.
2
.
The use of a pressurised air maintenance unit is
necessary.
All fittings, connecting lines and hoses must be dimen-
sioned for the required air pressure and volume.
Avoid restrictions in the air supply resulting from, e.g.,
pinching, kinking or stretching!
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
Disconnect the air supply.
Disconnect the air supply when the machine is not
in use, before maintenance work and for the
changing of the tools.
Check the direction of rotation setting
before operating the machine!
Keep hands away from the rotating tool holder as
well as the tool.
Use only flawless insertion tools that are not worn.
Defective insertion tools can cause injuries.
Pay attention to firm seating of the insertion tools!
Be careful in confined working conditions.
As a result of the reaction torque, injuries can occur
from squeezing or pinching.
Be careful when screwing in long screws; danger
of sliding off.
Place the machine on the screw/nut only when
switched off.
Secure the workpiece.
Use clamping devices or a vice to hold the work-
piece in place. In this manner, it is held more se-
curely than with your hand and makes possible the
operation of the machine with both hands.
Be careful of torque reaction!
For high torque settings and reduced operating
pressure, the clutch no longer disengages.
Bosch is only able to ensure perfect functioning of
the machine if the original accessories intended for
it are used.
English–1