Placing The Subwoofer; Connecting The Subwoofer - Harman JBL SUB 100P Manual Del Propietário

PLACING THE SUBWOOFER

The performance of a subwoofer is directly related to its placement in the listening room
and its physical position relative to the other speakers in the system.
While it is true that in general our ears do not hear directional sounds at the low
frequencies where subwoofers operate, when installing a subwoofer within the limited
confines of a room, the reflections, standing waves and absorptions generated within the
room will strongly influence the performance of any subwoofer system. As a result, the
specific location of the subwoofer in the room does become important to the amount and
quality of bass that is produced.
For example, placing the subwoofer next to a wall generally will increase the amount of
bass in the room; placing it in a corner (1) generally will maximize amount of bass in the
room. However, corner placement can also increase the destructive effect of standing
waves on bass performance. This effect can vary depending on the listening position –
some listening positions may yield very good results while others may have far too much
(or too little) bass at certain frequencies.
In many rooms, placing the subwoofer along the same plane as the left and right
speakers (2) can produce the best integration between the sound of the subwoofer and
that of the left and right speakers. In some rooms, the best performance could even
result from placing the subwoofer behind the listening position (3).
We strongly recommend that you experiment with placement before choosing a final
location for your subwoofer. One way you can determine the best location for the
subwoofer is by temporarily placing it in the listening position and playing music with
strong bass content. Move around to various locations in the room while the system is
playing (putting your ears where the subwoofer would be placed), and listen until you find
the location where the bass performance is best. Place the subwoofer in that location.

CONNECTING THE SUBWOOFER

TO A RECEIVER OR PREAMP/PROCESSOR WITH A LOW-PASS FILTERED DEDICATED SUBWOOFER OUTPUT (LFE)
Receiver/Processor
SUBWOOFER LFE
OUT
NOTE: This subwoofer / LFE cable is not included, but
can be purchased from an electronics retailer.
TO A RECEIVER OR PREAMP/PROCESSOR WITH PREAMP OUTPUTS
Receiver/Processor
PREAMP
OUTPUT
NOTE: This special subwoofer / LFE cable is not
included, but can be purchased from an electronics
retailer. An RCA Y-Adapter cable can also be used to
make this type of connection.
1.
Surround Left
Speaker
POWER
PHASE
MODE
ON NORMAL
AUTO REVERSE
SUBWOOFER
PWR
BLUE: ON
INPUT
RED: STANDBY
• Be sure to turn the Crossover on the subwoofer fully
clockwise when using this type of connection. This
type of setting bypasses the subwoofer's internal
crossover and uses your receiver or processor's
crossover.
• Check your receiver or processor menu settings and
set the subwoofer selection to 'On' or 'Yes.'
Please be sure to review the owner's manual for your
receiver or processor for more information on speaker
setup and configuration.
POWER
MODE PHASE
ON NORMAL
AUTO REVERSE
SUBWOOFER
PWR
INPUT BLUE: ON
RED: STANDBY
• We recommend setting the subwoofer's Crossover
setting to 80Hz for mid-sized speakers, higher for
smaller (satellite) speakers, and lower for larger
floorstanding speakers.
TV
Center
Front Left
Speaker
Speaker
3.
SUBWOOFER
INPUT
CROSSOVER VOLUME
50Hz 150Hz MIN MAX
SUB 100P
POWER
POWER
INPUT
ON
OFF
SUBWOOFER
INPUT
CROSSOVER VOLUME
MIN MAX
50Hz 150Hz
SUB 100P
POWER POWER
INPUT
ON
OFF
2.
Front Right
Speaker
Surround Right
Speaker
3
www.jbl.com