CMS XRD S Manual De Instrucciones página 11

well as the helmet, is decidedly simpler and gives best results when it is carried out immediately
after use.
Never use gasoline, benzene, cleaners for glass or other products and chemical solvents, because
they may compromise the quality of the visor.
Do not wipe the visor with heat sources.
Do not use sharp or pointed objects to remove dirt from the visor, to avoid scratching.
Do not apply the visor stickers or tape.
Follow the same instructions as well to clean the plastic parts of the helmet as air intakes and
mechanisms visor. To remove dirt, dust or insects of the pieces that you cannot reach with the
cloth, try using compressed air. If risk of soiling the inside of the helmet during this operation,
remove all padded and secure it properly with newspaper.
Care and maintenance of the helmet
The helmet must be treated and handled with care to maintain the
integrity of the security functions.
To clean the shell and liner of the helmet, use a product specifi-
cally for the purpose. If you have no such products you can use a
soft cloth moistened with mild soap and warm water. For interior
non-removable internals and internal EPS can pass a soft cloth
moistened with mild soap and warm water. To rinse, use a soft
damp cloth.
The removable interior can be washed by hand or machine wash
in warm water (max.35 °) and mild soap. The internal parts must
always be left to dry in the open air without being exposed to heat.
Before using the helmet again after cleaning, make sure all parts
are completely dry in order to avoid unpleasant odors or mold.
Never use gasoline, benzene or other type of chemical solvent
product because they can damage the operation and structure of
some components of the helmet and weaken the protective func-
tions.
For the same reason, we advise you not to repaint the helmet,
since the solvents present in paints can damage the materials that
make up the helmet.
Do not modify in any way the helmet (e.g., practicing holes or
cuts in the shell, pressing the internal EPS, focusing restraint sys-
tems or internal parts) because this way the structure weakens
and threatens to undermine the protective capabilities. If neces-
sary you should replace a component. Use original parts CMS,
directing your dealer.
Avoid any behaviors or uses of helmet that can hurt performance:
Do not put the helmet on the pedestals of mirrors or banks to
avoid damaging the liner or even falls.
Do not sit on the helmet and put it on the floor.
-Do not leave the helmet in places such as reservoirs and seat of
the bike, which can easily fall and be damaged. For the same rea-
son, keep the helmet out of the reach of children and animals that
could make him fall, scratch it or damage it.
Do not remove at all structural parts of the helmet, as the icecap
internal belt, accessories.
Do not expose the helmet to intense sunlight.
Care and maintenance of the visor and plastic parts
The visor must always be kept in excellent condition, to ensure a
perfect visibility. When the visor is scratched, damaged or cannot
be cleaned properly, it must be replaced immediately.
For proper cleaning of the visor, remove the helmet visor and
clean it using a soft cloth and warm water: if the visor is very dirty,
you can add soap to the water. Rinse the visor down running wa-
ter and dry it with a soft dry cloth. The cleaning of the visor, as
English
11