CMS XRD S Manual De Instrucciones página 7

Removal procedure peak
To run this process it is recommended a flat base.
To remove the visor, follow the figure: Starting from one of the two sides of the helmet, turn the
screw counterclockwise (1) remove screws, taking care to place them in a safe and plane place
(2) remove visor (3 .)
To install the visor, reverse the removal instructions below.
Removal procedure external visor
To run this process it is recommended a flat base.
To remove the outer visor, follow the figure: Picking up the visor to its maximum (1) starting
from one side of the helmet, push button (2) and pull the first piece (3), then the second one (4).
Repeat the procedure on the other side of the helmet. Extract visor.
To install the external visor, reverse the removal instructions below: Place the visor in the posi-
tion it was removed respecting the fittings in reverse order of removal, apply a little pressure on
the visor for a good fit.
English
7