Tripp-Lite B126-1A1-WHD1 Manual Del Propietário página 4

Installation
Notes:
1. Ensure all equipment being connected is powered off prior to installation.
2. For best results, position the IR transmitter near the HDMI source and the IR receiver near the
display.
3. If the wireless signal is obstructed by walls (especially brick or glass) or other obstacles, the quality
and distance of the signal will likely be reduced.
Blu-ray
HDMI Cable
1. Optional: Attach the included mounting hardware to the transmitter and receiver units,
then mount them to a desired location.
2. Connect the HDMI source device to the HDMI Input port on the transmitter unit using
an HDMI cable, such as Tripp Lite's P568-Series High Speed HDMI Cables.
3. Connect the IR-OUT (Tx) cable to the IR-OUT port on the transmitter unit.
Note: IR-OUT (Tx) cable has IR-OUT marked on the bottom of the IR bulb. Place the bulb of the IR-
OUT (Tx) cable in an area with a direct line of sight to the HDMI source device (e.g. Blu-ray player).
4. Connect the external power supply to the transmitter unit and plug it into a Tripp Lite
Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution Unit (PDU).
5. Connect the HDMI display to the HDMI Output port on the receiver unit using a
P568-Series High Speed HDMI Cable.
6. Connect the IR-IN (Rx) extension cable to the IR-IN port on the receiver unit.
Note: IR-IN (Rx) cable has IR-IN marked on the bottom of the IR bulb. Place the bulb of the IR
receiver cable in the general area you will be using the source device's remote control.
7. Connect the external power supply to the receiver unit, and plug it into a Tripp Lite
Surge Suppressor, UPS or PDU.
8. Turn on power to the connected equipment.
16-12-095-933699.indb 4
/DVD
™
HDMI Extender
Tx Transmitter
HDMI Extender
Rx Receiver
4
TV (Up to 1080p)
HDMI Cable
2/16/2017 3:27:27 PM