Special Safety Instructions For This Device; Overview Of The Controls; Assembly - Super Ego Hidrolimpiadora 100 Instrucciones De Uso Y Mantenimiento

GB
Operating instructions
Special Safety Instructions for this Deviceo
- If the high-pressure washer is handled incorrectly,
this may prove hazardous for individuals and
materials. Children and young people are often not
able to evaluate risks. They should therefore not be
allowed tooperate the device.
- Never leave the device unattended as long as the
main switch is turned on.
- During work breaks the manual spray gun should be
secured by use of the lock.
�
Here there is a Danger of Death!
- Never operate the device in rooms where there is a
risk of explosion.
- Never touch the mains plug with wet hands.
- As additional protection the installation of a residual
current device(RCD) with a rated breaking current of
not more than 30mA is recommended in the electric
circuit of the bathroom. Please consult a qualified
electrical engineer.
- Before operating the device always check the mains
power cable, the mains plug and high-pressure hose
for damage. Damaged cables must be replaced
immediately by an approved qualified electrician..
Damaged high-pressure hoses are to be replaced
immediately.
- The following should be taken into consideration
when cleaning motor vehicles: Tyres and tyre valves
may be damaged by the high-pressure jet and then
burst. The first indications of this are discoloration of
the tyre. Only the fan jet should be used. A distance
of at least 50cm should be maintained during the
cleaning process.
�
Here there is Danger of Injury
- The jet of water emerging from the high-pressure
nozzle causes the manual spray gun to recoil.
- Please ensure you are standing in a stable location..
Hold the manual spray gun and the jet pipe as tightly
as possible.
- If required ,you should wear appropriate protective
clothing as protection against spray.

Overview of the controls

1. Main ON/OFF switch
2. High-pressure outlet
3. Water connection with filter
4. Coupling section
5. Jet pipe was high-pressure nozzle
6. Supply hose(not supplied)
7. High-pressure hose
8. Manual spray gun
9. Main plug
10. Lock

Assembly

Remove the motor device and the accessories from
the box. Also remove any packing materials that may
be present.
High-Pressure Hose
Use the high-pressure hose (7)to connect the high-
pressure outlet(2)of the cleaner and the connection to
the manual spray gun(8).Please use a size 17 spanner
to help you.
Jet pipe with nozzle, standpipe ,manual spray
gun
The jet pipe with nozzle can only be mounted on the
standpipe and the standpipe only on the manual spray
gun. These components have quick-action connectors.
10