Connection Requirements; Instructions For Use - Super Ego Hidrolimpiadora 100 Instrucciones De Uso Y Mantenimiento

Align the coupling of the pipes with one of the
connections. The connection is locked by pressing and
turning simultaneously in a clockwise direction.
The connection is opened by first pressing the
components together and then turning the pipe in an
anticlockwise direction
Detergent Container
The detergent container can only be connected to the
standpipe.
The detergent container consists of 2 components.
The quick-acting closure with nozzle. can be attached
to or separated from
The standpipe by pressing and turning simultaneously.
1. The container ,After this has been filled it is screw
on to the quick-acting closure.

Connection Requirements

Electrical connection
Only connect the machine to a properly installed
safety socket. Before inserting the mains lead into the
socket,check whether the voltage you intend to use
complies with that of the machine.
Extension Lead
Only extension leads that are protected against water
spray should be used with high mechanical strength
and an internal diameter of at least 3 x 1,5mm
Water Connection
The high-pressure cleaner is suitable for connection to
a standard domestic water supply. Please observe the
regulations of your water supply company.
The supply hose(not supplied)should have the
following dimensions:
Length: min7,5m
For the connection values please see the technical
data contained in these instructions.
Diameter: min.1/2"
Operating instructions

Instructions for use

Use
- The device is intended for private use only.
- Clean machines, vehicles, buildings, tools, facades,
terraces, garden tools etc. with the high-pressure
water jet. If necessary you can use detergents.
- Please use detergents sparingly,.noting the quantities
recommended by the producer.
Please note
- The cleaning of motors/engines and other surfaces
that may be covered with oil is only allowed in
conjunction with an appropriate oil separator.
- Do not clean any surfaces that may contain
hazardous materials, such as asbestos.
Water
- If necessary, clean the supply water with a water
filter, Any impurities in the water could damage the
pump.
- Operating the high-pressure cleaner without water
will damage the pump.
- Please ensure before switching on the cleaner that
the water supply is available.
Bleeding the Device before Use
- The device must be connected to the electricity and
water supply(See "Connection" points 1-3 in the
section "Operation").
- Unscrew the high-pressure hose (7)from the high-
pressure connection(2) of the device.
- Switch on the device and allow it to run until the
water coming out of the high-pressure connection
no longer contains any bubbles.
- Switch off the machine at the main switch(1) and
screw the high-pressure hose(7)back on.
Cleaning Method
1. Spray the detergent sparingly on to the dry surface.
Allow it to act for a short time without letting the
detergent dry.
.
2
2. Rinse off the loosened dirt with the high-pressure
jet.
Water Loss
It is normal for the pump to lose small quantities of
water. If there is a sizeable leak,please contact our
service department.
11
GB