Evolution 005-0002 Instrucciones Originales página 9

www.evolutionpowertools.com
Note: Height-adjustable secondary clamps are provided
on the adjustable clamps. (Fig. 17).
This feature enables these clamps to be configured
to accommodate the wide variety of chopsaw bases
presently available from various manufacturers.
Attaching a Chop Saw to the Universal Mounting Table
• Place the chop saw onto the table with the right
hand (RH) edge of the machine's base resting against
the two fixed clamps.
• Adjust the adjustable clamps to firmly grip the base
of the machine.
• If necessary adjust the secondary clamps to provide
enhanced positive location and extra grip to the
upper surface of the chop saw base. (Fig.18) Tighten
these in place using the supplied hex key.
• Tighten the clamps to secure the machine onto the
table.
Note: When fitting your chop saw to the stand please
ensure the fixed clamps are to the right of the unit when
viewing from the front. (Fig.19)
Test the security of the machine by gently trying to rock
the machine backwards and forwards. There should be no
detectable movement of the machine on the table.
CUTTING OPERATIONS
Refer to the Instruction Manual provided by the
manufacturer/supplier of the machine fitted.
WARNING: Remove any machine fitted to the stand
before the stand is prepared for storage.
Note: As during preparation, placing the stand on end or
upside down on a clean work bench (or similar rigid work
surface) may help with the following procedure.
• Return (if necessary) the legs to their minimum
extension setting.
• Operate the relevant locking/unlocking lever to
release the leg from its service position.
• Rotate and fold each leg into its storage
position, ensuring that they lock in place.
Use the carrying handle (and/or extra competent help) to
transport the stand to a dry, secure storage location.
Fig. 17
Fig. 18
Fig. 19
9
EN