Using The Product As Intended; Safety Notes; Contents; Symbols And Their Meaning - marklin 20997 Manual Del Usario

1. Using the Product as Intended

This uncoupler track is for remote controlled uncoupling of
Märklin H0 locomotives and cars.

2. Safety Notes

Make sure you read the following safety notes before using
this Märklin product for the first time.
• IMPORTANT! Not suitable for children under 3 years. Sharp
edges and points required for operation. Danger of choking
due to detachable small parts that may be swallowed.
• This product may only be used indoors.
• Do not store this product in direct sunlight or areas with
extreme swings in temperature or high humidity.
• Visually examine the switched mode power pack and its
power cord at regular intervals (depending on the frequen-
cy with which you use it to run the trains), at least once a
week, to make sure it is not damaged. Do this examination
with the power pack unplugged from the household
current. If you have the least suspicion of damage, do not
use the power pack again until it has been repaired by the
Märklin Repair Department.
2.1 Important Notes
• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
8
• This product may only be used in conjunction with the
66361/66365 switched mode power pack, a feeder track
with a 4-pin socket such as the 253391 base station, and
the 72752 control box.
• The 66361/66365 switched mode power pack is not a toy.

3. Contents

1 x Uncoupler track
1 x Extension cable
1 x Set of instructions for use
1 x Warranty card

4. Symbols and Their Meaning

indicates adherence to all basic safety and health
requirements.
Toy for use with a transformer
max.
Rated voltage
18 V

5. Setup and Connections

Setup may be done only under the supervision of adults.
Unplug the switched mode power pack from the household
current in order to prevent damage during setup. Do not plug
the switched mode power pack in the wall outlet again until
you are finished with all of the wiring.
!
The cable that comes with the uncoupler track may not be
altered.