Connecting Using Hdmi - Pioneer DV-600AV-S Manual De Instrucciones

Connections
Connecting the digital output
This player has both optical and coaxial-type
digital audio outputs for connection to an AV
receiver. Connect whichever is convenient.
Depending on the capabilities of your AV
receiver, you might have to set up this player to
output only digital audio in a compatible
format. See Digital Audio Out settings on
page 39 and refer to the operating instructions
that came with your AV receiver.
Note that SACD audio is not output through
these jacks, so this connection should be in
addition to, rather than instead of, a 5.1
channel analog connection.
• Connect one of the DIGITAL AUDIO
OUT jacks on this player to a digital input
on your AV receiver.
AV receiver
AV CONNECTOR (RGB) TV/AV Receiver
DV-600AV only: For an optical connection, use
an optical cable (not supplied) to connect the
OPTICAL DIGITAL AUDIO OUT jack to an
optical input on your AV receiver.
For a coaxial connection, use a coaxial cable
(similar to the supplied video cable) to connect
the COAXIAL DIGITAL AUDIO OUT jack to a
coaxial input on your AV receiver.
To coaxial/optical
digital input
AC IN
OPTICAL COAXIAL
DIGITAL AUDIO OUT
DV-600AV

Connecting using HDMI

If you have a HDMI equipped monitor or
display, you can connect it to this player using
a commercially available HDMI cable.
The HDMI connector outputs uncompressed
digital video, as well as almost every kind of
digital audio that the player is compatible with,
including DVD-Video, DVD-Audio (see below
for limitations), SACD, Video CD/Super VCD,
CD, WMA, MP3, MPEG-4, AAC, Divx video and
WMV.
• Use an HDMI cable to connect the
HDMI OUT interconnect on this player to
an HDMI interconnect on a HDMI-
compatible monitor.
To HDMI
interconnect
VIDEO OUT
C L
P
B SL
P Y SR SW R
R
HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT AUDIO OUT (5.1ch)
DV-600AV
The arrow on the cable connector body should
be face up for correct alignment with the
connector on the player.
HDMI-compatible display
02
15
En