Warning Caution - MADER KM0408312 Manual Del Usuario

INSTALLING HANDLE
Install handle in bracket. Position handle
in a comfortable operating position and
tighten four M5 x 25 screws.
BLADE INSTALLATION
Install holder A, the tri‐blade, holder B,
teeth washer, in this order, then clamp
with a left hand thread net.
Align hole of gear case and holder A, and
insert S=4mm bar wrench.
Rotate blade‐fastening nut with plug box
wrench in clockwise direction until
securely tightened.
Install the pin 2 x 16 and disjoin it.
WARNING
EXCESSIVE VIBRATION STOP ENGINE
IMMEDIATELY
Excessive vibration of blade means that it
is not properly installed. Stop engine
immediately and check blade. Blade
improperly installed will cause injury.
Use only our company original cutting
equipment parts when servicing the unit.
ASSEMBLY
CAUTION
RIGHT HANDLE ASS'Y
CAP,UPPER
BRACHET
LEFT HANDLE ASS'Y
BAR WRENCH
GEAR CASE
SAFETY GUARD
HOLDER A
HOLE
TRI‐BLADE
HOLDER B
TEETH WASHER
M5 x 25
SCREWS
LEFT NUT
PIN 2 X 16