Cutting With A Nylon Head - MADER KM0408312 Manual Del Usuario

CUT‐OFF KNIFE
ON LEFT SIDE
Line head rotates in a CLOCKWISE
direction. The CUT‐OFF KNIFE will be on
the right side of the debris shield.
COUNTER CLOCK WISE ROTATION

CUTTING WITH A NYLON HEAD

DEBRIS
CUT ON
THIS SIDE
WARNING
The proper debris shield must be in place
on the unit when nylon cutting line is used.
The cutting line can flap around if too much
line is exposed. Always use the plastic
debris shield with cut‐off knife when using
nylon cutting heads.
For nearly all cutting, it is good to tilt the
line head so that contact is made on the
part of the line circle where the line is
moving AWAY from you and the debris
shield.(See appropriate picture)This results
in the debris being thrown AWAY from you.
WARNING
Tilting the head to the wrong side will shoot
the debris TOWARDS you. If the line head is
held flap around if too much line is exposed.
Always use the plastic debris shield with
cut‐off knife when using nylon cutting
heads.
WARNING
Use only quality nylon monofilament line of
the diameter 2.5mm.Never use wire or
wire‐reinforced line in place of nylon
trimmer line. Load your nylon line cutting
head only with nylon trimmer line of the
proper diameter.
WARNING
Use extreme caution when operating over
bare spots and gravel, because the line can
throw small rock particles at high speeds.
Debris shields on the unit cannot stop
objects which bounce or ricochet off hard
surfaces.
CAUTION
CAUTION
CAUTION
CAUTION