How To Use The Warm Up Key - Kinetec Breva Manual Del Usuario

Beginning
To stop the unit
To select the Extension/Flexion movement
To select the Warm Up mode
Or
To select the Inversion/Eversion movement
To select the right or left foot
To select the Warm Up mode
Start the movement
Warm Up rules:
The Kinetec Breva starts at 70% of the full ROM, increasing 5% of the range every other cycle until the pre-set ROM is reached.
Comments:
- The parameters modification should always be done while the unit is sopped.
- Pauses and By-Pass mode are not available during warm up cycles.
- The Warm Up cycles are only working when the movement is firstly run.
- To start new Warm Up sessions press twice the « Warm Up » key.
- The calculation mode used enables reaching the pre-set ROM in approximately seven full cycles.
Example:
For a Warm Up treatment with a pre-set ROM from 40° to 30°.
The first cycle starts from 32° to 22° and increase 5% each cycle
Keys to press
Pl/flex
20
Pl/flex
20
Pl/DOR FLX W.UP
Or
10
Ev
10
Ev
10
30° 30° 30°
-5° -5°
-40° -40° -40°

How to use the WARM UP key ?

Display
DOR/flex
stop 10 5
DOR/flex
stop 10 5
20 STOP 10 5
INVERSION/evers.
Right :+ left :-
Ev right inv
stop 10 10
wup right inv
stop 10 10
wup right inv
RUN 10 10
Use of the hand control
Remarks
Check if the hand control is not locked
(See page 5).
To change the movement value if
necessary see page 7.
The value change at the speed of the
movement.
11
GB