Using The Support; Bench Processing - aquatechnik BBS 32 Instrucciones De Utilizacion

NB: The mechanical expander (G) has anti-slide teeth. When performing belling
(expansion of pipe), a minimum shortening of bell occurs. This does not alter the
proper bell length.
Warning: Once the coupling cycle is over, the equipment goes back to its initial
position, ready to perform the next working cycle. Otherwise, pull the emergency
return valve (C) as described and illustrated under section "Manual Return of
Coupling tool BSB 32".
5. Clutch the safety
stop.
NB: ll
is re-used, using aquatechnik grease is recommended (Item# 71391).
6. Screw the cap up to the anti-unscrewing safety notch (use the special wrench
series 50600).
NB: The connection may be disassembled by unlocking the cap by means of the
special wrench. DO NOT RE-USE caps already locked.
7. In order to change pipe diameter, unscrew the mechanical expander (G) and set
the one with the desired diameter, following the steps described in section 1.
8. When you put the coupling tool BBS 32 in its case, be sure that the conical pin
(D) is back into return position.
PROCESSING REM RKS

USING THE SUPPORT

The Coupling tool BBS 32 is equipped with a special multi-purpose support that may
be used as a support for bench processing and as a stand for the Coupling Tool.
Picture 3
16 ENGLISH
connection into the coupling obtained by pushing it up to the
connections are prelubricated. If lubricant is lacking or connection

BENCH PROCESSING

Place the Coupling tool BBS 32 into the
special housing in the middle of the support
N (see picture). The special shape of the
support locks the equipment in a balance
condition preventing it from falling and
comfortably allows for bench processing on
any work surface.
BBS 32
(patented)