Coupling Sliding - aquatechnik BBS 32 Instrucciones De Utilizacion

4) If the elastomerc adapter is not perfectly into its
seat, start the coupling-tool and make the conical
pin go out completely; after that, wait 30
seconds.
Finish the coupling cycle and push the elastomeric
5)
adapter until it positions in the specific seat. In
order to make this operation easier, use a plastic-
head hammer.
DI METER 14
COLOUR BROWN
REMOVING THE EL STOMERIC D PTER
To remove the damaged elastomeric adapter (H), you must:
start the Coupling tool BBS 32 until the mechanical expander reaches its
1)
maximum expansion position;
2) cut the elastomeric adapter lengthwise by using a cutter.
Warning: use the cutter with due caution.
SOLVING M IN PROBLEMS

COUPLING SLIDING

If during the coupling phase an unusual sliding of the pipe is observed, to the extent
that the obtained coupling is either too short or narrow, and subsequent inserting of
pipe into the
alcohol, make sure that the mechanical expander (G) is screwed up to its stop, and
repeat coupling.
NB: never lubricate the elastomeric adapter by using oil, grease, or other
lubricating products.
18 ENGLISH
16 18
WHITE GREEN
connection is difficult, clean the elastomeric adapter (H) with
20 26
RED YELLOW
BBS 32
(patented)
Picture 7
Picture 8
32
BROWN