Safety Warnings - MELICONI AT 38 Instrucciones De Uso

AMPLIFIED INDOOR ANTENNA
MODEL AT 38 Meliconi amplified indoor antenna is able to receive and amplify digital
terrestrial TV signals and DAB radio signals in the VHF (band 3, 174~230MHz) and UHF
(470~790MHz) bands.
The antenna can be connected to a TV set or a digital terrestrial decoder.
A
• This product is for use indoors only; do not use outdoors.
• Keep away from water: the device must not be exposed to drips or splashes of water.
Do not use in a damp environment.
• The product must not be exposed to sources of excessive heat, such as the rays of
the sun, fire or the like.
• Do not use a power supply unit other than the one supplied with the device.
• The power supply unit must be easily accessible so that the device can be separated
from the mains electricity supply.
• If you notice an anomaly regarding the power supply unit, disconnect it from the mains
electricity socket immediately.
• To avoid electric shocks, do not tamper with the device or try to repair it.
• This product is not a toy, and must not be left within the reach of children or pets.
• Before connecting the devices, disconnect them from the mains electricity supply.
B
• Place the antenna in a suitable position, for example near a window and or in the
direction of the TV broadcasting unit, away from metal objects, electrical equipment
and reinforced concrete walls, which would limit its function.
• Connect the cable of the Meliconi antenna to the antenna socket on the back of the TV
set or the digital terrestrial decoder (figure 1). If the decoder is fitted with an F-female
type antenna socket, use an F-male / IEC-female socket adapter (not included).
• Use the AC/DC power supply unit supplied; insert the cable into the antenna power
supply inlet and connect the power supply unit to a 230V~ / 50Hz electrical socket
(figure 2).
• For use on boats or in camper vans, the antenna can be connected to the DC 12V
50mA inlet (figure 2), observing the polarity indicated on the inlet socket. (adapter not
supplied)
• Turn the knob (figure 3) to switch on the antenna and position it for maximum
amplification.
• Check that the antenna is switched on; the LED light should be on.
• Switch on the TV or decoder and select the desired channel.
AT-38
INSTRUCTIONS
Thank you for choosing MELICONI.

Safety warnings

Installation
GB
3