Tabla de contenido
Publicidad
Alineamiento del aserradero
7
Procedimiento de alineamiento completo
LT25/LT27 rev. C7-D3:
See Figure 7-23. Use the horizontal adjustment bolts to adjust the horizontal alignment of
the drive-side blade wheel. If the blade tracks too far back on the drive-side blade wheel,
locate the long U-bolt on the right which mounts the bearing housing to the mounting
plates. Loosen the hex nuts on the U-bolt (on the back side of the back plate). Loosen the
jam nuts on the horizontal adjustment bolts. Tighten the adjustment bolts to spread the
plates apart and bring the blade forward.
If the blade tracks too far to the front, loosen the jam nuts on the horizontal adjustment
bolts and back the adjustment bolts out. Tighten the hex nuts on the long U-bolt (on the
back side of the back plate).
Be sure to tighten all nuts against the mounting plates when the adjustment is complete.
Horizontal
Adjustment Bolts
SM0240B
FIG. 7-23
Previous revisions:
To adjust the horizontal alignment of the drive-side blade wheel, locate the long U-bolt on
the right which mounts the bearing housing to the mounting plates. Locate the jam nuts
on the bolts between the two mounting plates. If the blade tracks too far to the front of the
drive-side blade wheel, turn the jam nuts toward the bearing housing. If the blade is too
far back, turn the nuts away from the bearing housing. Make sure to tighten the jam nuts
against the mounting plates when the adjustment is complete.
Ajuste del rodillo del carril
El hacer correctamente los ajustes garantiza que el carruaje de corte se desplace
uniformemente a lo largo del carril y que la sierra permanezca paralela con el armazón
de la bancada.
1. Utilizando los controles de la manivela de , mueva el carruaje de manera que la sierra
Alineamiento del aserradero
2597doc121307
7-28
Publicidad
Tabla de contenido
