Automatic Defrost - Honeywell TP30AWKN Manual Del Usario

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
WI-FI MODE^
When the Smart Dehumidifier is connected to the wifi function, the
illuminated.
^ THIS IS ONLY FOR MODEL TP30AWKN / TP50AWKN / TP70AWKN WITH WI-FI SMART FEATURES
AUTO DRAIN PUMP MODE*
The Auto Drain Pump function helps to remove condensation vertically and horizontally.
Press the to activate the Pump function, the
Press button to activate the pump function. When water Pump starts, LED displays "PU" for 5
seconds on every 1 minute. When water pump does not work, there is no "PU" display.
IMPORTANT: Water pump will start only as water in bucket reachs the level of pump starting
condition. The bump will not draw full bucket of water on its cycle of runing. The pump function will
be restored after a power outage.
*THIS IS ONLY FOR MODEL TP70PWK / TP70PWKN WITH BUILT-IN DRAIN PUMP
PUMP DOES NOT AUTO-RESTART AFTER POWER FAILURE
WARNING: For models with Auto Drain Pump, the Auto Drain Pump will not automatically restart
after a power outage to prevent leakage in case the drain tube was disconnected during power
failure. The Auto Drain Pump Mode button must be manually reactivated in the event of a power
outage.

AUTOMATIC DEFROST

Frost may build up on the internal coils of the unit. When there is frost build up, the internal
compressor will turn off and the fan will continue to run until the frost has melted. Once the internal
coils have defrosted and dried, the compressor or fan will automatically restart and dehumidifying
will resume.
indicator light will be illuminated.
EN 12
indicator light will be