System Requirements - Tripp-Lite U439-002-CG2 Manual Del Propietário

System Requirements

• (x2) 2.5" or 3.5" SATA Hard Drive
• Computer with an available USB port. A USB Type-C 3.1 Gen 2
port is required to achieve maximum data transfer speeds.
Note: The offline cloning function will not work if the U439-002-CG2 is
connected to a computer. For more information, see Offline Cloning
Instructions.
Docking Station Instructions
Notes:
• Hard drives are sensitive to static electricity and must be handled properly
to prevent data loss. Always handle your hard drive with caution. Wear
an anti-static strap (Tripp Lite model: P999-000) when transporting it, or
touch a grounded metal surface to discharge yourself of static electricity
prior to handling the drive.
• If your SATA hard drive has not been formatted, you will first need to
format it using your computer's Disk Management utility.
1. Connect the included power supply to the unit and plug it into
a Tripp Lite Surge Protector, Power Distribution Unit (PDU), or
Uninterruptible Power Supply (UPS).
2. Insert your 2.5" or 3.5" SATA hard drive into an available bay on the
docking station. Make sure the drive is securely seated on the SATA
connector. Repeat this step to connect an additional hard drive.
3. Connect the included USB 3.1 Gen 2 cable between your
computer and the docking station.
4. Turn on power to the docking station using the ON/OFF button
on the back of the unit. The red "Power" LED will illuminate to
indicate power is being received. The red LEDs for drive bays A
and B will illuminate to indicate a hard drive is connected to the
corresponding port and recognized by the computer.
18-09-283-933818.indb 3
3
9/26/2018 12:01:11 PM