Tripp-Lite U439-002-CG2 Manual Del Propietário página 4

Offline Cloning Instructions
Notes:
• Make sure there is no USB connection between the U439-002-CG2 and
a computer. The offline cloning function will not work if the U439-002-
CG2 is connected to a computer.
• If your SATA hard drive has not been formatted, you will first need
to format it using your computer's Disk Management utility before
proceeding with cloning.
• The Replica Drive's (Bay B) capacity must be larger than that of the
Master Drive (Bay A). If its capacity is smaller or equal to the Master
Drive, you will not be able to clone information onto it.
• Prior to cloning, ensure there is no important data stored on the Replica
Drive. Once cloning begins, all data on the Replica Drive will be deleted
and replaced with the cloned data from the Master Drive.
• Be alert, the cloning process will take some time (approximately
2.5 hours per 1 TB). Do not turn off power or remove the hard drive
before the LED progress bars indicate the process is completed.
1. Connect the included power supply to the unit and plug it into
a Tripp Lite Surge Protector, Power Distribution Unit (PDU), or
Uninterruptible Power Supply (UPS).
2. Insert the 2.5" or 3.5" SATA Master hard drive (the drive that
you want to clone) into the Master Drive (Bay A) of the docking
station.
3. Insert the 2.5" or 3.5" SATA Replica hard drive (the drive that
the cloned data will be copied to) into the Replica Drive (Bay B)
of the docking station.
18-09-283-933818.indb 4
4
9/26/2018 12:01:11 PM