Operation - Bucket Head BH01000 Manual Del Usuario

WARNING: To reduce the risk of fire, explosion, or damage to Vac:
!
• Do not leave Vac running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid exiting
exhaust, or abnormal motor noises. Immediately stop using Vac if you notice
these signs.
• Do not leave Vac plugged-in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vac in areas with flammable gases, vapors, or explosive dust in
the air. Sparks inside the motor can ignite airborne flammables. Flammable
gases and vapors include: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol, or aerosol sprays. Flammable dusts include: coal, magnesium,
aluminum, grain, or gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not use Vac as a sprayer.
WARNING: To reduce the risk of electric shock or injury:
!
• Do not expose to rain or allow liquid to enter the motor compartment. Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Do not service Vac while it is plugged-in. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into water,
return it to an independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not allow the connection to come into contact with liquid.
• Do not vacuum toxic materials to reduce the risk of inhaling the vapors or dust.
Align the powerhead latches with the
bucket handle/bail. Press down firmly
over each latch to engage the latches
with the bucket.
After plugging the power cord into the
wall receptacle, turn the unit "ON" by
pushing the switch from position "O" to
position "I". The symbols used on the
switch are international symbols. The "O"
is the "OFF" position and the "I" is the
"ON" position.

OPERATION

To remove the power head from the
bucket, remove the hose from the
powerhead and rotate the bucket
handle/bail away from the power cord.
Slightly spread both latches away from
the bucket and lift the powerhead off.
Powerhead
Latch (2) To reduce the risk of tip-over when
carrying by the handle/bail, align the
Bucket Head
attach points and be sure the bail is
snapped into the retention grooves on
the latches.
Bucket
5
= OFF
latches above the bail
®
"I" - "ON"
Position
= ON
"O" - "OFF"
Position