Installation Notes; Connecting In.k1000+ To The Spa Pack - Gecko in.k1000+ Manual De Usuario

Installation

Installation notes

vent hole
The vent hole on back of keypad should not be blocked�
When installing the keypad on the spa, a minimum angle
of 4 degrees must be respected�

Connecting in.k1000+ to the spa pack

Note: always shut power down before connecting an accessory to the spa pack�
To connect the keypad, remove the cover, then insert the in�link connector into the appropriate keypad connector
(as illustrated)� Route the cable through one of the molded strain relief channels on the bottom right side of the spa
pack (as illustrated)� Fill the remaining space with the foam gaskets supplied� Don't forget to replace the cover and all
screws (torque to 8 in� lb max (0�9 N�m))�
The back of the in�k1000+ should not be enclosed where
water can gather, but instead in a cut out�
keypad
4°
cover
water
Install the keypad facing the outside of the spa� Also make
sure that the spa cover can never get in contact with the
keypad glass surface�
Main keypad in�k1000+
Connect the
main keypad as
indicated here�
+
1
9