Work C-72 Instrucciones De Usuario página 6

PROGRAMMING A SCENE
This function allows you to program a scene in the memory. This scene can be
called in any moment. To program a scene:
With a DMX controller, program a scene using any of the 72 channels
1.-
availables.
2.- Hold pressed the SCENE (8) button for 5 seconds until the message GOOD
appears in the LCD display (3).
To recall this scene press the SCENE button. The message STORE will
3.-
appear in the LCD display indicating that the unit is executing a saved scene.
CHASE MODE
To activate the CHASE mode press the CHASE button (7), the message CHAS
will appear in the LCD display, indicating that the unit are now executing a 72
channe ls CHASE until this fun ction b e disa bled by the user.
CHANGING THE SIGNAL OUTPUT L,EVEL
This unit is prepared to send analogic signals of +/-10, +/-12 or +/-15 Volts. You
must determine what voltge requires your analogic unit and change the ouput
tension if it is necessary. The predefined output level is 10 Volts. To change the
output level :
1.- Turn off the device.
In the rear panel you can find several switches (16). Use them to select the
2.-
output voltage, following this instructions :
To obtain 10 Volts, move the switches 1 & 4 to the ON position.
To obtain 12 Volts, move the switches 2 & 4 to the ON position.
To obtain 15 Volts, move the switches 3 & 4 to the ON position..
3.- In the rear panel is placed a switch of 2 positions (17). Use it to select positive
or negative ouput.