MTD 19B70028OEM Manual Del Operador página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

25.
Be sure that the blade is fully raised and is in the straight
forward position when in transport.
26.
When turning close to buildings or passing through narrow
areas, be sure to allow sufficient clearance for the blade.
27.
Avoid overturns—Do not clear snow or any other material
across the face of slopes. Exercise extreme caution when
changing direction on slopes. Do not attempt to clear
steep slopes.
28.
Make adjustments only when the blade is attached to the
machine.
29.
Keep the blade in the lowest possible position when
changing the angle, reversing or removing the blade. Be
sure that feet, and any other body parts, are not under the
blade when the adjustments are made.
30.
Never operate the machine at high speeds with the blade
locked in the stationary position. A collision with a hidden
obstacle may damage the blade cutting edge and unseat
the driver.
31.
To ensure maximum side and ground clearance do not
transport the blade in the angled or tilted position.
32.
If situations occur which are not covered in this manual, use
care and good judgement. Contact an authorized service
dealer.
Slope Operation
Slopes are a major factor related to loss of control and rollover
accidents, which can result in severe injury or death. If a slope is
steeper than a 15° incline, do not operate this equipment on that
area. Exercise extreme caution while operating on slopes.
Do:
1.
Use extreme care when operating close to ditches, fences
or on hillsides.
2.
Travel straight up and down slopes, not across. Exercise
extreme caution when changing direction on slopes.
3.
Travel slowly while on a slope. Always keep the forward
speed limited when going down slopes to take advantage
of the engine braking action.
4.
Keep all movement on the slopes slow and gradual. Avoid
starting or stopping on a slope.
Do Not:
1.
Do not travel near drop-offs, ditches or embankments. The
machine could suddenly turn over if a wheel is over the
edge of a cliff, ditch, or if an edge caves in.
2.
Do not stop or start suddenly when going uphill or
downhill. Be especially cautious when changing direction
on slopes.
3.
Do not turn sideways to the hill. The machine may roll over.
If you must turn, go slow and do so carefully and gradually.
WARNING:
follow the warnings and instructions in this manual and on the machine.
4
S
2 — i
ection
mportant
Your Responsibility—Restrict the use of this power machine to persons who read, understand and
SAVE THESE INSTRUCTIONS!
S
o
p
afe
peration
racticeS
Children
1.
Tragic accidents can occur if the operator is not alert to
the presence of children. Children are often attracted to
the machine. They do not understand the dangers. Never
assume that children will remain where you last saw them.
Avoid run over accidents.
a.
Keep children out of the immediate area of the
vehicle and in watchful care of a responsible adult
other than the operator.
b.
Be alert and turn the vehicle OFF if a child enters the
area.
c.
Before and while backing, look behind and down for
small children.
d.
Never carry small children, they may fall and be
seriously injured or interfere with safe machine
operation.
e.
Use extreme care while approaching blind corners,
doorways, shrubs, trees or other objects that may
block your vision of a child who may run into the
path of the vehicle.
f.
Remove key when machine is unattended to prevent
unauthorized operation.
2.
Never allow children under 14 years old to operate this
machine. Children 14 years old and over should read and
understand the operation instructions and safety rules
for the vehicle and equipment, and should be trained and
supervised by an adult.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido