IKEA FRAMTID HGA4K Manual Del Usuario página 12

ENGLISH
made by means of a rigid copper or
steel pipe with fittings complying with
local regulations, or by means of a
continuous-surface stainless steel hose
complying with local regulations. The
maximum length of the hose is 2 linear
metres.
A
C
- Connect elbow (A) or (B) supplied with
to the hob inlet main pipe and interpose
the washer (C) supplied, in compliance
with EN 549.
- Use elbow (A) for France and elbow (B)
for all other destinations.
- IMPORTANT: if a stainless steel hose
-
Electrical connection
-
-
-
-
-
B
Assembly
After having cleaned the perimeter surface,
apply the supplied gasket to the hob.
C
Position the hob in the worktop opening
made respecting the dimensions indicated
in the Instruction.
NOTE: the power supply cable must be long
enough to permit its upward extraction.
To secure the hob, use the brackets provided
with it.
Fit the brackets into the relevant bores
shown by the arrow and fasten them by
means of their screws in accordance with
the thickness of the worktop.
Make sure that the outlet is near the product
is used, it must be installed so as not to
touch any mobile part of the furniture.
It must pass through an area where
there are no obstructions and where it is
possible to inspect it on all its length.
After connection to the gas supply, check
for leaks with soapy water. Light up the
burners and turn the knobs from max
position to minimum position
check flame stability
WARNING
This operation must be performed by a
qualified technician.
The electrical connections must comply
with local regulations.
The earthing of this appliance is
compulsory by law.
Do not use an extension cord.
IMPORTANT: the data relevant to the
voltage and power absorption are
indicated on the rating plate.
12
to
L
Earth
(yellow/green)
N