Installation Instructions
Anti-tip bracket considerations
Product
When installing the product into the cabinet
Tape or Fixer
30
English
Dacor_BRW9000R_IM_DA68-03621J-02_EN.indd 30
Wall
Anti-Tip-Bracket
1. Bracket positioning: follow the cabinet-
specific height table.
2. Screws: Tighten all 3 screws on the
brackets.
3. Push the product up against the rear
wall of the cabinet.
4. Spacer: If using the spacer, you must
follow the positioning specifications of
the bracket (see the table above).
CAUTION
• The height of the spacer must be
calculated based on the depth of the
cabinet.
• The spacer must be fixed separately
from the cabinet.
Before positioning the product in the
cabinet, plug in the power cord. Then,
attach the power cord near the front of the
cabinet opening using tape or fixer such as
clip, pin, etc.
After positioning the product inside the
cabinet, make sure the power cord is
positioned on the top of the product (as
shown in the in the figure).
2020-10-19
10:53:05