Installation - Urmet 1723/46 Manual Del Usuario

INSTALLATION

1. Loosen the keypad closing screw using the screwdriver insert provided.
2. Open the device as shown.
3. Remove connector J3.
4. (Only if the product is arranged next to the panel).
Fix the panel to the wall following the installation instructions.
Position the centring template (A), provided with the panel, under the panel and then arrange the panel
(1) by the side and mark the fi xing points B of the anchor bolts (2).
5. Drill the holes and fi x the panel to the wall with the screws and anchor bolts included with the product.
6. Connect to the system and insert the connector J3.
Power the system and program it.
7. Close the metal lid of the panel.
1
3
During installation, in order to avoid breakages to
the device, it is necessary to disconnect the J3
connector from the printed circuit.
5
DS1723-008B
J3
2
4
1
1
2
A
2
B
9