Operating Instructions - Blue Clean BCXP22300P Instrucciones De Uso Y Cuidado

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
• Make sure the power switch is off (light will be off).
• Unwind the power cord completely and plug
into a grounded 120 volt outlet.
• Turn on water supply at the faucet to completely open.
• Turn the safety lock button on the spray gun to
unlocked. While pointing the spray gun in a safe
direction, squeeze the trigger on the spray gun until
there is a steady stream of water, letting the water
and air out of the hose.
/
OFF 0
/
ON I
• Turn the power switch to the "ON" (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature. Squeeze
the spray gun trigger to begin pressure washing.
12
lock
K
/
OFF 0
/
ON I
• Squeeze the spray gun trigger to begin pressure
washing.
• Begin power washing by squeezing the trigger on the
spray gun all the way into the handle.
• Release the spray gun trigger to stop the power
washer.
• Allow the motor to come to a complete stop before
squeezing the trigger again.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning
on while squeezing trigger after rapid squeezing. Use
slow, deliberate trigger pulls to avoid this.
• Always test a small area to avoid chance of damaging
the surface.
Adjusting Soap Levels on Foam Cannon
Twist knob to adjust the level of soap as indicated on
the top of the Foam Cannon (O). Twist toward the
higher concentration of bubbles for more soap, or the
opposite direction for less.
I
O