Removing The Whisk From The Whisk Holder; Removing The Ejector; Splash Guard Assembly; Cleaning - Robot Coupe CMP 250 V.V Manual Del Usuario

• Removing the whisk from the whisk holder

While griping the
ejector in one
A
B
hand and the holder
in the other, pull
B
the ejector in the op-
posite direction of
the arrow.

• Removing the ejector

Hold the whisk by the
wires
With the other hand,
pull the ejector
B
the direction of the ar-
row (see figure).
A
SPLASH GUARD
ASSEMBLY
- With a flat
screwdriver, uns-
crew the " V "
screw from the
ring.
B
- Separate the A
A
and B arms from
C
the ring and put
it on the foot
C, keeping the
marking " U.P "
on the side of the
1
V
motor.
D
- Put the screw back
on the ring and tigh-
ten it.
Cover the ring with
the splash guard
protection sliding it
all along the foot C in
the arrow 1 direction,
the flange D must be
oriented down.
A
Be careful : align the
front sides of the two
parts.
- To remove the splash
B in one hand.
guard protection for
cleaning follow these
in
A
instructions in the
reverse order.
W A R N I N G
• Always unplug the power mixer before
cleaning it!
• Always dilute bleach according to the
instructions on the label
• Never run the power mixer through a
dishwasher!
• Clean according to local health department
regulations.

• Motor housing

The power mixer must be clean through all stages
of production. Clean between each job using a deter-
gent or disinfectant. Dilute the detergent/disinfectant
following the instructions normally specified on it's
packaging container. Use a cloth lightly dampened
(not dripping) with the cleaning solution. Do not
allow liquid to come into contact with the electrical
components contained within the housing. Be careful
when cleaning around vents do not allow liquid to
drip or seep into the housing. Use a cloth lightly
dampened (not dripping) with water to remove
detergent/disinfectant then dry using a clean cloth.
After using the power mixer in a hot mixture, cool the
bottom of the tube in cold water before disassembling
the bell from the tube.
Clean immediately after use to prevent product from
sticking to surfaces.
Never immerse motor housing and/or handle
in liquid! The housing contains the electrical
components and is not sealed against liquid.

CLEANING

Contact with liquid can cause damage to the
blender and serious injury to the operator.

• Tube and bell

There are two ways to proceed:
Simple cleaning procedure
Submerge the tube and bell in water and run for a
few seconds to clean. Unplug the power cord.
Complete cleaning procedure
Unplug the power mixer and rinse the bell under a
water tap. Remove the bell from the tube, then
remove the blade (wear cutting gloves) ! Be careful
to avoid damaging the surface of the blade shaft
and the watertight seals. Always dilute the deter-
gent/disinfectant (see above). Thoroughly dry all
parts before reassembling.
W A R N I N G
9